Advertisement
SPRAYING
Turn safety lever
of gun to OFF.
SHUTDOWN AND CLEANUP
Set power
Trigger gun until
switch to OFF.
pressure is relieved.
Unscrew tip & guard
from gun. Clean gun filter,
Place drain
tube and
inlet screen, tip, guard
and manifold filter with
siphon tube
water and brush.
in pail of water.
WASTE
Place drain tube in waste pail
Set power switch to ON, and
and siphon tube in
increase pressure
container of Pump Armor
™
until sprayer starts.
AUTOCLEAN 2
GUIDE + HEAVY DUTY PRIME VALVE
™
Remove suction and drain tubes from
paint. Place drain tube into waste pail
and wipe suction tube clean.
Place gun in
Screw connector
AutoClean connector.
onto gun.
Turn valve to prime position
and then back to AutoClean
When finished, remove
to repeat cycle.
trigger clip from gun handle.
KBS BRANDSKYDD AB
GRACO N.V. Industrieterrein Oude Bunders
Slakweidestraat 31 • B-3630 Maasmechelen
www.kbs.se
Tel: +32 (89) 770 700 • Fax: +32 (89) 770 777
E-mail: info@graco.be • http://www.graco.be
Point gun at area to be sprayed about 30 cm from surface, and begin moving gun before triggering.
A good spray pattern is evenly distributed as it hits surface. Set pressure just high enough to spray without heavy edges.
Use smaller tip size for thinner material and a larger tip size for thicker material if pressure adjustment cannot achieve even spray pattern.
* for AutoClean 2
: see bottom of this page
™
Turn prime valve
to Prime position
Remove gun filter
(down).
assembly.
Turn pressure control knob
to lowest setting, set power
switch to ON, and increase
pressure until sprayer starts.
Let sprayer run and flush itself for
2 minutes.
As soon as Pump Armor
comes out of drain tube,
set power switch to OFF.
H
O
2
Place suction tube in
Close drain valve.
appropriate cleaning fluid.
Switch power ON.
Slide open end
over back of handle.
Unscrew connector from gun.
Remove gun from connector.
Remove manifold
filter and spacer.
Keeping gun triggered
Keep gun triggered
into water pail, turn prime
into pail for 1 minute,
valve to Spray position
until water coming out
(horizontal).
of gun is clean.
Screw inlet screen onto
siphon tube, replace
Wipe outside of sprayer, hose
manifold filter and spacer,
and gun with rag soaked in
and assemble gun with
water or
filter, tip and guard.
mineral spirits.
To save paint from hose and pump,
trigger gun into paint pail and increase
pressure. When cleaning fluid appears,
release gun trigger.
Rotate trigger lock
clip 90° to lock
trigger open.
With clean fluid, briefly trigger gun
into waste pail several times to
Close drain valve.
clear any debris from front of gun.
© 2002, 2006, 2009 Graco N.V. · Form No. 328006 E (rev.D)· 05/09 · Printed in Europe.
All information, illustrations, and specifications in this document are based on the latest product information
available at the time of publication. The right is reserved to make changes at any time without notice.
Assemble gun
Unscrew inlet screen
without filter.
from siphon tube.
Set power switch to OFF,
turn pressure control knob to
lowest setting, and turn prime
valve to Prime position (down).
Fill throat packing nut
with TSL
™
Turn pressure all the way down.
Open drain valve.
Turn valve to AutoClean
™
position
to start cleaning process.
Install tip and guard and briefly trigger
gun into waiste pail to clean tip.
Reverse tip if necessary.
Graco is certified ISO 9001.
Advertisement
