Lamp Settings - Optoma W311 User Manual

Quick Resume
If the projector is accidentally turned off, this feature allows the projector to
be instantly powered on again within 100 seconds of power down.
Power Mode (Standby)
Set whether the Device -> PJ function works when the projector is in standby
(powered off but connected to AC power).
Eco: The Device -> PJ function will not work when the projector is in
standby.
Active: The Device -> PJ function will work when the projector is in
standby.
Note
When HDMI Link is set to Off, the standby mode is < 0.5W.

Lamp Settings

Lamp Hours
Display the projection time.
Lamp Reminder
Choose this function to show or to hide the warning message when the
changing lamp message is displayed.
Brightness Mode
Bright: Choose "Bright" to increase the brightness.
Eco.: Choose "Eco." to dim the projector lamp which will lower power
consumption and extend the lamp life.
Dynamic: Choose "Dynamic" to dim the lamp power which will be based
on brightness level of the content and adjust lamp power consumption
between 100% and 30% dynamically. The lamp life will be extended.
Eco+: Choose "Eco+." to dim the lamp power which will be based on
brightness level of the content and adjust lamp power consumption
between 80% and 30% dynamically. The lamp life will be extended.
Lamp SPA Mode
Choose "On" to turn on the Lamp SPA Mode. Choose "Off" to turn off the
Lamp SPA Mode.
Lamp Reset
Reset the lamp hour counter after replacing the lamp.
Optional Filter Settings
Optional Filter Installed
EN-48