Related Manuals for Security Tronix ST-CCTV-VBAC16
Summary of Contents for Security Tronix ST-CCTV-VBAC16
-
Page 1: Installation Manual
INSTALLATION MANUAL© ST-CCTV-VBAC16 16-Channel Active UTP Video Receiver Copyright North American Cable Equipment, Inc. v2.0 10/26/10... -
Page 2: Package Contents
One installation manual PRODUCT DESCRIPTION The ST-CCTV-VBAC16 is an 16-channel active video receiver that receives a balanced signal over unshielded twisted pair (UTP) cable and converts it to an unbalanced signal for a display device (e.g., monitor, DVR). Sixteen channels of video imaging simultaneously can be received over UTP cable, processed and displayed. -
Page 3: Unpacking And Handling
This unit is designed to use AC power. Using a power source other than 90 – 260VAC will damage the unit. c. Only qualified installers are allowed to install and test the unit. d. The ST-CCTV-VBAC16 is intended for indoor installations. If installed outdoors proper safety and lightning grounding are required. 4. PRODUCT DIAGRAM... -
Page 4: Wiring Connections
5. WIRING CONNECTIONS a. The UTP connections to the ST-CCTV-VBAC16 is done using the unit’s RJ45 connectors. The advantage of using the RJ45 connector is up to 4 devices can be share a single UTP cable. If using the RJ45 connector the wiring order follows the TIA/EIA-568B specification. - Page 5 Image brightness and sharpness may vary according to the distance between the camera and the ST-CCTV-VBAC16. A potentiometer and set of DIP switches are assigned to each of the ST-CCTV-VBAC16’s channels. The potentiometer is used to adjust “brightness” while the DIP switches adjust “sharpness”.
-
Page 6: Troubleshooting
Video image appears scrambled – (i) Check to be sure all UTP wiring connections and polarities are consistent at each device and the ST-CCTV-VBAC16 RJ45 input(s). b. Video image has some ripples – This may be caused by electro-magnetic interference.