Write Command Examples
Function
Command
Brightness
(BRT140)
Power
(PWRO)
Power
(PWR1)
Error Conditions
Not all commands are supported for all projectors. If an unsupported com-
mand is issued, the command will be ignored. If a command is received that
is not understood, a '?' character will be returned indicating the command
was not understood.
Limitations
The projector cannot respond to commands coming in at a high-rate. There-
fore, a delay must occur between commands to ensure that the command
gets properly executed. To assure the projector can process a command,
wait 3 seconds before entering the next command.
The Step column refers to increasing or decreasing the menu bar position
since the On-screen Display is not an exact match of values. For example,
Step 2 changes the data by 2 through the CLI (Command Line Interface).
The menu bar is up (or down) by 1.
Response
Sets the brightness to 140
Turns power off
Turns power on
41
Com-
Function
mand
About (Source Info)
ABT at W
0: n/a
1: enable
Active Iris
IRI at RW
0: Off
1: Presentation
2: Film
Aspect Ratio
ARZ at RW
0: Native
1: 16:9
2: 4:3
Auto Image
AIM at W
0: n/a
1: enable
Auto Power
APO at RW
0: disable
1: enable
Auto Source
ASC at RW
0: disable
1: enable
Blank
BLK at RW
0: off
1: on
Min
Max
De-fault
0
1
n/a
0
2
1
0
2
2
0
1
n/a
0
1
0
0
1
1
0
1
0
St
e
p