Table of Contents
Advertisement
Quick Links
INVERTER
ARC
WELDER
80 Amp
INSTRUCTION MANUAL
SPECIFICATIONS
Input Voltage:
230-240V ~ 50Hz
Welding Current:
10 - 80A
Arc Electrode Size:
1.6 - 2.5mm
Duty Cycle:
12%@80A (23.2V) DC
Cord & Plug:
2.0m/10A
Weight:
5.0kg
The input supply is protected by a 16A fuse.
ozito.com.au
ON
STOP
WHAT'S IN THE BOX
ON
STOP
Inverter Welder
Arc Electrode Holder
Earth Clamp
IWA-100
Advertisement
Table of Contents
Related Manuals for Ozito IWA-100
Summary of Contents for Ozito IWA-100
- Page 1 Input Voltage: 230-240V ~ 50Hz Welding Current: 10 - 80A STOP Arc Electrode Size: 1.6 - 2.5mm Duty Cycle: 12%@80A (23.2V) DC Cord & Plug: 2.0m/10A Weight: 5.0kg Earth Clamp The input supply is protected by a 16A fuse. ozito.com.au IWA-100...
-
Page 2: Know Your Product
KNOW YOUR PRODUCT SETUP & PREPARATION INVERTER WELDER 1. ASSEMBLY 1 Welding Current Control 5 Positive Output Terminal 2 Power On LED 6 Carrying strap WARNING: ENSURE THE TOOL IS SWITCHED OFF AND 3 Thermal Overload LED 7 Power cable DISCONNECTED FROM THE POWER SUPPLY BEFORE 4 Negative Output Terminal PERFORMING ANY OF THE FOLLOWING STEPS. -
Page 3: Operation
OPERATION 2. CONTROLS 3. ARC WELDING Preparation WARNING: THE POWER SUPPLY FOR THIS PRODUCT SHOULD Before welding ensure that: BE PROTECTED BY A RESIDUAL CURRENT DEVICE (RATED AT • You have read and understand the safety section of this manual. 30MA OR LESS). -
Page 4: Arc Welding
The slag also helps to produce a bead of the desired contour. • To introduce alloys into the weld deposits in special type electrodes. IWA-100... -
Page 5: Troubleshooting
(with tolerance ±10%) at your local Bunnings Warehouse. Rated maximum input current For further information, or any parts not listed here, visit Warning www.ozito.com.au or contact Ozito Customer Service: Non-load voltage Current rating Australia 1800 069 486 Load time Reset time New Zealand 0508 069 486 E-mail: enquires@ozito.com.au... -
Page 6: Electrical Safety
Note: The supply of 230V and 240V on Ozito tools are interchangeable for Australia and New Zealand. If the supply cord is damaged, it must be replaced by an electrician or a power tool repairer in order to avoid a hazard. -
Page 7: Warranty
• Failure to perform maintenance as set out within the instruction manual. • If the tool is disassembled or tampered with in any way. • Professional, industrial or high frequency use. OZITO Australia/New Zealand (Head Office) 1-23 Letcon Drive, Bangholme, Victoria, Australia 3175. 0514...
Need help?
Do you have a question about the IWA-100 and is the answer not in the manual?
Questions and answers