Denon DN-500BD User Manual page 25

o DHCP: When set to On, DN-500BD will obtain IP address information via Dynamic Host
Configuration Protocol (DHCP). When set to Off, you must enter the IP address, Subnet
Mask, Default Gateway, DNS1, and DNS2 manually:
 Use the left/right cursor buttons () to move between the squares.
 Use the number buttons (0–9) to select numbers for each square.
 Press the down cursor button () to delete a number.
 Press OK to confirm the entire address.
 Press Return to cancel and return to the previous menu.
o Wireless Setting: Select how you want to connect to the wireless network: Scan (display
available networks), Manual (enter the network service set identifier [SSID] manually), or
Auto (connect automatically to an available network). The Interface setting (see above)
must be set to Wireless.
If you select Auto, select how you will connect to the network: PBC (press the WPS/Reset
button on your router within 120 seconds of selecting Next) or PIN (enter the PIN shown on
the screen into the software control panel for your wireless router or access point).
o Proxy Setting: When set to Disable, DN-500BD will not use a proxy server. When set to
Enable, DN-500BD will use a proxy server with the information in the Proxy Host and
Proxy Port windows.
 Proxy Host: Use the cursor buttons () to move between the buttons in the
window. Press OK to press that button. Press Return to return to the previous menu.
 Proxy Port: Use the number buttons (0–9) to select numbers for each square. Press
Return to return to the previous menu.
Device Setup
•
Firmware
o Version: DN-500BD's current firmware version.
o Upgrade: When you are upgrading DN-500BD's firmware, select how DN-500BD will
access the firmware file: Disc, USB Storage, or Network. Follow the instructions included
with the firmware update file.
•
Setting
o Remote Control Code: If you are using other similar Denon Professional products that
unintentionally respond to DN-500BD's remote control, select a different remote control
code to keep its communication separate: Code 1, Code 2, or Code 3.
o HDMI CEC: When set to On, DN-500BD's remote control can send commands to DN-
500BD as well as a TV connected to the HDMI output (your TV must support HDMI CEC).
When set to Off, DN-500BD's remote control will send commands to DN-500BD only.
o Setup Management: Select Export to save all of DN-500BD's current settings as a .bin file
on a connected USB drive. Select Import to import a previously saved .bin file of DN-
500BD's settings from a connected USB drive.
o Reset Factory Defaults: Select OK to erase all of DN-500BD's current settings and restore
its original/default settings, or select Cancel to keep the current settings. If you select OK,
you will see the Initial Wizard screen (as you did when you first set up DN-500BD).
o Serial Bit Rate: Select the serial bit rate: 9600 or 38400.
25