Makita TD021D Instruction Manual page 6

A
B
1. Switch
010329
And then turn the switch to A side for clockwise rotation
or to B side for counterclockwise rotation.
Tool speed is increased by increasing rotation force on
the switch. Release the switch to stop.
CAUTION:
Always check the direction of rotation before
•
operation.
Change the direction only after the tool comes to a
•
complete stop. Changing the direction of rotation
before the tool stops may damage the tool.
When not operating the tool, always set the lock
•
lever in the locked position
Lighting up the front light
CAUTION:
Do not look in the light or see the source of light
•
directly.
1
2
010326
To start the tool, first move the lock lever to the released
position to release the switch.
A
B
1. Switch
010329
B
A
1
.
1. Lock lever
2. Light
B
A
1
To put on the light only, rotate the switch to the A or B
side a little.
To not only put on the light but also start the tool rotate
the switch to the A or B side more.
Release the switch to stop the lamp and tool.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
•
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
ASSEMBLY
CAUTION:
Always be sure that the lock lever is in the locked
•
position mark
removed before carrying out any work on the tool.
Installing or removing driver bit or socket bit
004521
Use only the driver bit or socket bit shown in the figure.
Do not use any other driver bit or socket bit.
For European and North & South American
countries, Australia and New Zealand
A=12mm Use only these type of bit. Follow the
procedure (1).
B=9mm
(Note) Bit-piece is not necessary.
006348
For other countries
To install these types of bits, follow
A=17mm
the procedure (1).
B=14mm
(Note) Makita bits are these types.
To install these types of bits, follow
A=12mm
the procedure (2).
B=9mm
(Note) Bit-piece is necessary for
installing the bit.
006349
6
and the battery cartridge is