Subaru April BRZ Service Manual page 66

PRE-DELIVERY INSPECTION
7) Press the access key "UNLOCK" button once.
8) The driver's door unlocks and the alarm system
is in the non-monitoring condition.
9) Check that the alarm does not sound when any
of the doors are opened.
10) Press the access key "LOCK" button once with
one door open.
11) Check that the buzzer sounds to warn that the
door is not fully closed.
12) Close all doors.
13) Illuminates to indicate monitoring prepared
condition (indicator light illuminates).
14) The security indicator light flashes once for two
seconds 30 seconds after the condition of step 13)
is reached, and the system enters the monitoring
condition.
15) Press the "UNLOCK" button on the access key
once to turn the system into non-monitoring condi-
tion.
Pre-delivery Inspection
16) Momentarily press the "LOCK" button of the
power door lock switch with any one door open.
• Driver's side
PI-00814
• Passenger's side
17) Close all doors.
18) When all doors are locked, the indicator light il-
PI-00813
luminates to indicate that the alarm system is in the
monitoring prepared condition.
19) The security indicator light flashes once for two
seconds 30 seconds after the condition of step 18)
is reached, and the system enters the monitoring
condition.
20) When the alarm system is in the monitoring
condition, use the inner lock knob or the key to un-
lock the door.
21) Check that the alarm condition occurs (horn
sounds continuously, hazard light flashes, security
indicator illuminates).
22) Check that the condition described in 21) con-
tinues for 60 seconds or more, or until the access
key "UNLOCK" button is pressed, or until the posi-
tion switch is turned ON with the correct access
key.
23) When none of above is applicable, perform
troubleshooting for the security system.
24) Turn off the security system.
PI-00814
PI-12
PI-00776
PI-00779