Advertisement
Replace the Water Reservoir, then replace
The green Brew Size Indicator Lights
5
6
the Water Reservoir Lid.
above the BREW Button will flash. If they
are not flashing, make sure the Handle is
Place a large mug - that can hold 300 ml
pressed all the way down. Press the BREW
(10 oz) or ½ pint - on the Drip Tray.
Button to start priming. The lights will
continue to flash until priming is complete.
DO NOT lift the Handle while heating
or brewing.
www.keurig.co.uk
ADD WATER
ADD WATER
AUTO OFF
AUTO OFF
HEATING
HEATING
DRAIN BREWER
DRAIN BREWER
DESCALE
DESCALE
POWER
POWER
BREW
BREW
PUSH TO BREW
PUSH TO BREW
Your Keurig
brewer will automatically fill
7
®
(priming it) and the water will be heated.
This takes less than 5 minutes. While
heating, the red HEATING Light will come
on. When ready, the red light will turn off.
DO NOT remove or puncture the foil lid of the
K-Cup
pack.
TM
Lift and lower the Handle. DO NOT insert
Once finished, pour the hot water
8
9
a K-Cup
pack. The blue BREW Light will
into the sink.
TM
flash. Press the BREW Button to start a
cleansing brew. Hot water will flow into
your mug.
NOTE: If your brewer has been exposed to
temperatures below freezing, we recommend you
allow two hours for an unpacked brewer to warm
to room temperature before powering on.
ADD WATER
AUTO OFF
HEATING
DRAIN BREWER
DESCALE
POWER
BREW
PUSH TO BREW
While your brewer refills and reheats between
10
brews, the red HEATING Light will come on.
During this time the pump may cause a
vibration noise. This is normal. The red light
will turn off when the water has heated and the
brewer is ready.
The one-time priming process is now complete
and you are ready to enjoy your first cup!
Remove used K-Cup
pack after brewing.
TM
CAUTION: K-Cup
pack will be hot.
TM
Advertisement
