Manitowoc AUCS Q Use And Care Manual page 18

Installation Instructions
Connection to Ice Machine (cont.)
COMMUNICATION WIRE CONNECTION
Insert the low voltage communication wire through
the ½" conduit connecting the AuCS
machine. machine.
QDUAL ONLY: The communication wire is attached to the rear of the ice
machine control box. The communication wire included with the
not used.
QDUAL
COMMUNICATION
PORT
2-10
®
A to the ice A to the ice
CONTROL BOARD
COMMUNICATION
WIRE
GROUND WIRE
(Q1300/Q1800 ONLY)
ROUTE WIRING
THROUGH
ACCESS HOLES
AS SHOWN
30 AND 48 INCH
Low Voltage Communication Wire Connection
Plug into the jacks on the ice machine control board Plug into the jacks on the ice machine control board
® ®
and the AuCS and the AuCS A control board. (Refer to drawing for A control board. (Refer to drawing for
routing communication wire in ice machine.) routing communication wire in ice machine.)
22 INCH
AUCS CONTROL
BOARD
COMMUNICATION
PORT
Section 2
COMMUNICATION
WIRE
SV1642G
®
is
AuCS A