Installation
•
Turn off the host system.
•
Connect the power
if needed.
•
Plug the connector
of the cable to the
host system.
•
Turn on the host
system.
•
For RS232 scanner,
there are 3 ways to
supplying the power,
use external +5V
power supply, use
optional power
cable (KBDC) which taking the power from KB
wedge, or if the host supports +5V power from
pin 9.
•
When connected, the scanner will emit three
short beeps twice and the indicator flash green
light.
•
If the defaults value is not fit your demand,
please configure the selection depended by
programming menu.
4