Table of Contents
Advertisement
replacement lamps
User only
ionization
lamps without
wire. XOP
LAMP
REPLACEMENT
End of life can be confirmed with the Flash LED on the rear panel. The LED
flashes
dimly
with each trigger pulse: if
the lamp, the lamp is spent. If the LED does not flash,
with the
control signal.
To replace the lamp
Warning:
Verify that the fixture is disconnected from AC power before
opening the front covert
Whether or not you value your life,dlaconnect the fixture from AC power
and allow the capacitor to discharge for 1minute.
2
When the fixture ia cool,remove the two marked acrews on the aidea of
the fixture and open the front glua cover.
3
Disconnect the lamp wires at the screw terminals.Lift the old lamp out of
the holder.
' Lay the new lamp on the front glaas above the lamp clipa,with the end with 2
wires on the aide cloaeat to the mains cable.
5
Important! Connect the two wlrea with white Inaulatlon (the electrode wlrea)
to the outside terminal on each end.Connect the wire with clear insulation
(the ionization wire) to the inaide terminal on the end cloaeat to the maine
cable.Puah the inaulation for each wire aa far aa it willgo into the connection
block.
8
Lift and tum the lamp over ao that the Ieada loop around the enda aa
ahown,then preaa the lamp into the clipa.
7
Cloae the front cover and replace the aide screws before applying power.
Melight that have beenprepared for
from
use
ionization
will not
work:.
an
wire
the
but
there
is no
LED lights
flash
their
may be a problem
7
with
an
from
whenever the combination of flash duration
flashes. For
example,
the blinder effect can be achieved with a flash duration of
0.25 seconds (250 ms) and a flash rate of 4 flashes per second, or a flash duration
of0.05 seconds (50 ms) and a flash
rate
of20 flashes per second.
In
3- and 4-channel DMX
mode,
the intensity of the blinder
1.
on
channel
Lamp power is electronically regulated to prevent the lamp from
fulls
overheating. The intensity
as power is reduced.
SINGLE
FLASH
start
To trigger single flashes,
with the intensity and flash
on
1.
the value
intensity
channel
When
of channel
once with the programmed intensity, duration, and effe
12
and
rate prevents pauses between
effect
is
controllable
rate
at 0 and then set an
I changes,
the
light will flash
Advertisement
Table of Contents
