Stihl MS 171 Instruction Manual page 56

English
Guide bars
STIHL reduced kickback bar (with green
label) for 3/8" P pitch
Rollomatic Mini 12, 14, 16 in.
cutting lengths: (30, 35, 40 cm)
Groove width: 0.043 in. (1.1 mm)
Saw Chains
STIHL reduced kickback bar (with green
label) for 3/8" P pitch
Picco Micro Mini Comfort 3
(61 PMMC3)
Pitch: 3/8" P (9.32 mm)
Drive link gauge: 0.043 in. (1.1 mm)
Chain sprocket
Spur chain sprocket or rim sprocket
6-tooth for 3/8" P
Cutting attachment MS 181, MS 181 C
Recommended cutting attachments in
compliance with Sec. 5.11 of ANSI
standard B 175.1-2000
Guide bars
STIHL reduced kickback bar (with green
label) for 3/8" P pitch
Rollomatic cut- 12, 14, 16 in.
ting lengths: (30, 35, 40 cm)
Rollomatic E
Light cutting 12, 14, 16 in.
lengths: (30, 35, 40 cm)
Groove width: 0.050 in. (1.3 mm)
54
Saw Chains
STIHL reduced kickback bar (with green
label) for 3/8" P pitch
Picco Micro Comfort 3 (63 PMC3)
Pitch: 3/8" P (9.32 mm)
Drive link gauge: 0.050 in. (1.3 mm)
Chain sprocket
Spur chain sprocket or rim sprocket
6-tooth for 3/8" P pitch
7-tooth for 3/8" P pitch
Bar and chain MS 211, MS 211 C
Recommended cutting attachments in
compliance with Sec. 5.11 of ANSI
standard B 175.1-2000
Guide bars
STIHL reduced kickback bar (with green
label) for 3/8" P pitch
Rollomatic cut- 12, 14, 16 in.
ting lengths: (30, 35, 40 cm)
Rollomatic E
Light cutting 12, 14, 16 in.
lengths: (30, 35, 40 cm)
Groove width: 0.050 in. (1.3 mm)
Saw Chains
STIHL reduced kickback bar (with green
label) for 3/8" P pitch
Picco Micro Comfort 3 (63 PMC3)
Pitch: 3/8" P (9.32 mm)
Drive link gauge: 0.050 in. (1.3 mm)
Chain sprocket
Spur chain sprocket or rim sprocket
6-tooth for 3/8" P pitch
7-tooth for 3/8" P pitch
Cutting attachment MS 171, MS 181,
MS 181 C, MS 211, MS 211 C
Observe the information about ANSI
standard B 175.1-2000 as well as the
definition "low-kickback saw chain" in
the section "Safety Instructions".
In order to comply with the kickback
performance requirements of Sec. 5.11
of ANSI standard B 175.1-2000, do not
use replacement saw chains unless they
have been designated as meeting the
ANSI Sec. 5.11 requirements on this
specific powerhead, or have been
designated as "low kickback" saw
chains in accordance with the ANSI B
175.1-2000 standard.
Since new bar/chain combinations may
be developed after publication of this
Manual, ask your STIHL dealer for the
latest STIHL recommendations.
MS 171, MS 181, MS 181 C, MS 211, MS 211 C