Table of Contents
Advertisement
Quick Links
SC401 1
1 Heat/1 Cool
Auto Changeover
Non-Programmable Electronic Thermostat
–
Residential (New Construction/Replacement)
–
Light Commercial
Installation, Operation & Application Guide
For more information on our complete range of American-made
products – plus wiring diagrams, troubleshooting tips and more,
visit us at www.icmcontrols.com
Parts Diagram
Down button
RC
RH
C
RC
O/B
FP
RH
Right (fan)
button
button
RC/RH Jumper
Field programming pins
Reset switch
Icon Descriptions
Room temperature
Fan operation icon
offset activated
Cooling operation icon
Lock mode activated
Heating operation icon
Specifications
Backlight Operation
Important Safety Information
WARNING!
Hardwire
Package Contents/Tools Required
To Remove Existing Thermostat
To Install Thermostat
Thermostat installation must conform to local and national building and electrical
codes and ordinances.
Be sure exposed portion of wires does not touch other wires.
Wiring Diagrams
(Both transformers must be in phase)
Fan
Control
IMPORTANT
Remote or Outdoor Sensor Installation (Optional)
sensor
sensor
Remote Sensor: (Shown: Optional ICM ACC-RT103 Remote Indoor
Remote or outdoor sensor reading can be displayed by
simultaneously pressing the Down and SYS buttons.
Configuration Mode
is in the
Press the
OFF
is in
Press the
or
Press the
Pressing the left
Left
button
Configuration Mode Settings
(F or C)
Press the
or
button
Press the
button
Press the
or
button
Press the
button
Press the
or
button
Press the
button
HP
O
HP
b
Heat
Heat
Press the
or
Press the
Select the number of degrees set temperature can be changed during
The mode cannot be changed when the thermostat is locked.
Press the
or
button
Press the
button
Press the
or
button
Press the
button
Press the
or
button
Press the
button
When not set to 0, will display.
Press the
or
button
Press the
button
button
Down
button
Right
button
Electric
Advertisement
Table of Contents
Related Manuals for ICM Controls SC4011
Summary of Contents for ICM Controls SC4011
- Page 1 SC401 1 1 Heat/1 Cool Important Safety Information Auto Changeover WARNING! Hardwire is in Non-Programmable Electronic Thermostat (Both transformers must be in phase) Press the button Down button Control Press the Package Contents/Tools Required Pressing the left Left Right button button –...
- Page 2 Testing the Thermostat Troubleshooting Press the button Symptom Remedy CAUTION! Press the button not present Heat Test (left) button inoperative present Press the button press Press the button Cool Test Press the button Status indicator light not on (left) button until c Press the button during call...
Need help?
Do you have a question about the SC4011 and is the answer not in the manual?
Questions and answers