Startup Test; The Hmi Startup Self-Testing _Power On - Cermate Technologies PV035-TST Installation Manual

Industrial Touch Panel PV Installation manual

Startup test

When turns on HMI, it will display self-testing screen. After completed, HMI will show
the system menu.
FigureA-1 When there are checksum errors, that could be RTC data missing, battery
failed or AP not being well downloaded.
FigureA-2 The HMI startup self-testing _power on
**When turns on HMI, system will automatically execute hardware testing first to make
sure hardware are normal or not. The result will show on the screen (Figure A-1/A-2). If
there are problems, the HMI will not communicate with P.L.C. normally.
When losing electricity during downloading or the PC breaks off downloading, after
restarting the HMI, it will show Firmware Memory Checksum and Application Memory
Checksum error. It means there is an abnormal downloading. To get a correct self-
testing result, please execute a correct download AP procedure again.
If losing electricity during downloading or the PC breaks off downloading when
upgrading OS, it will surely cause download failure. If you restart the HMI, it will not
display normal screens or even cannot be turned on. In that case, please set the DIP
SW2 to OFF, restart the HMI to get a default BIOS version B then execute the
upgrading OS program to get a correct OS version. Set the DIP SW2 to ON then the
HMI can be turned on normally.
A-15
PanelVisa