Related Manuals for Pacific Reach City
Summary of Contents for Pacific Reach City
- Page 1 Reach City(Trekking) owner manual Reach City(Trail) Accessories Assembly Owner manual Front/rear mudguards Front/rear carriers Kickstand...
- Page 2 Reach City(Trekking) owner manual Mudguard Assembly Procedures Step 1: Remove the rear and front mudgaurds and parts from the packing.
- Page 3 Reach City(Trekking) owner manual Step 2: (rear mudguard) For installation position the bicycle upside down, release the QR lever of the rear wheel. Move or remove the rear wheel. Use a 3mm allen key lock the mudguard stopper with 1mm play. Install the rear wheel and secure the QR lever.
- Page 4 Reach City(Trekking) owner manual Step 3: (rear mudguard continued) Place the bicycle back on its wheel. Fix the front end of mudguard first. Insert the zip ties into the plastic adaptor, then use a 4mm allen key to fix the adaptor in position. Cut the extra length of zip ties close to the plastic adaptor.
- Page 5 Reach City(Trekking) owner manual Step 4: (front mudguard) Use a 4mm allen key to assemble the plastic adaptor below the V-brake. Repeat for the other side. Clamp the mudguard stay. Use 10mm wrench to adjust the clearance. Cut the extra length of zip ties if necessary.
- Page 6 Reach City(Trekking) owner manual Carrier Assembly Procedures Step 1: (front carrier) Use a 3mm allen key to tighten the center stay of the carrier to the upper part of the fork, use a 5mm allen key fix the carrier stay to both sides. Note: put spacer in between the stay and fork before tightening all bolts.
- Page 7 Reach City(Trekking) owner manual Step 2: (rear carrier) The rear carrier includes carrier body, 1 long M5 bolt and 1 shorter M5 bolt, and 4 Igus self- lubricating plastic bushings. Use the bolt to push all the 4 Igus into the 4 holes on the back of the seat tube. Use 5mm allen key to tighten the carrier with longer bolt on top and short bolt at bottom.
- Page 8 Reach City(Trekking) owner manual Kickstand Assembly Procedures Use the 8mm allen key to tighten the kickstand, adjust the angle to prevent interference with crank.