Driver Log In & Status; Setting Truck Attributes - Navman M-Nav 900 User Manual

4.2 Driver Log In & Status
NOTE: These screens will only be displayed if your fleet administrator has set up the Driver Login and
Driver Status functions in the OnlineAVL2 application. If these have been enabled, you cannot use the M-
Nav 900/950 until you enter these details.
The M-Nav 900/950 must be in the docking
IMPORTANT:
cradle and connected to the Qube tracking device in order for
you to report your driver status to your fleet administrator
through the OnlineAVL2 application. The Navman Wireless icon
in the bottom status bar will show green when the M-Nav has a
connection to the Qube. It shows yellow when not connected.
If the login screen is displayed, use the onscreen keypad to
enter your Driver PIN (Personal Identification Number), then
select Log In.
If the 'Driver Log In Status' screen appears, select the
description that best describes your current status (e.g.
Driving, Other Work, Rest Break, etc.).
The check shows the current status.
4.3

Setting Truck Attributes

NOTE: The M-Nav 950 can store multiple truck profiles that define the dimensions and cargo of your truck.
The Garmin navigation software uses this information to select the best route for you based on the
information in the map data. However, this information may not be completely accurate. You are
responsible for confirming your route and avoiding any hazards.
If you wish to use Truck Routing, select Switch Mode and
select Truck/Lorry
11
M-Nav 900/950 | User Manual