Table of Contents
Advertisement
STEP 17- LINER INSTALLATION:
If you opted to use the stabilizers to help hold the wall up, then you will need to take them off while
installing the liner. Do not place the liner directly over the skimmer or skimmer return cutouts.
Place the liner at the center of the pool with the flap from the seams facing down. (For print liners, leave the
print side facing up.) Spread the liner so that the bottom seam of the circumference is resting on the cove
evenly around the pool. The seam should not be up on the wall or shifted to one side. These conditions will
cause tightness or stretching of the liner when the pool is being filled.
Fig. 56
Fig. 57
*NOTE: Line wall seam straight up and down, away from skimmer and skimmer return.
COVE
CORRECT LINER SEAM
Resting evenly on or near the cove
of the pool. Seam may not always
lie on the cove as pictured, so your
focus should be to keep the seam
consistent around the pool.
*Find the center point of each end of your liner and make sure you line
that up perfectly with the center point of each end of your pool.
POOL WALL
INCORRECT LINER SEAM
Shifted up wall.
This should not be done.
Correct this situation
if it occurs.
COVE
Advertisement
Table of Contents
