Slide-On-Rod" And Extender Features Of Sun Visor; Blind Spot Monitoring (Bsm) - If Equipped - Chrysler 300 2015 Operating Information Manual

"Slide-On-Rod" And Extender
Features Of Sun Visor
To use the "Slide-On-Rod" feature of the sun
visor, rotate the sun visor downward and swing
the sun visor so it is parallel to the side window,
grab the sun visor and pull rearwards until the
sun visor is in the desired position. To use the
extender feature of the sun visor, grab the
extender which is located at the rear of the visor
and pull rearward.
Slide-On-Rod Feature
70
BLIND SPOT MONITORING
(BSM) — IF EQUIPPED
The Blind Spot Monitoring (BSM) system uses
two radar-based sensors, located inside the
rear bumper fascia, to detect highway licens-
able vehicles (automobiles, trucks, motor-
cycles, etc.) that enter the blind spot zones from
the rear/front/side of the vehicle.
Rear Detection Zones
When the vehicle is started, the BSM warning
light will momentarily illuminate in both outside
rear view mirrors to let the driver know that the
system is operational. The BSM system sen-
sors operate when the vehicle is in any forward
gear or REVERSE and enters stand by mode
when the vehicle is in PARK.
BSM Warning Light
The BSM detection zone covers approximately
one lane width on both sides of the vehicle 12 ft
(3.8 m). The zone length starts at the outside
rear view mirror and extends approximately 10
ft (3 m) beyond the rear bumper of the vehicle.
The BSM system monitors the detection zones
on both sides of the vehicle when the vehicle
speed reaches approximately 6 mph (10 km/h)
or higher and will alert the driver of vehicles in
these areas.