Important Safety Instructions - Sarabec Loop System LA240 User Manual

The manufacturer cannot be held responsible for damage which is caused by not using this Loop System in compliance
with these safety instructions.
IF IN ANY DOUBT SEEK EXPERT ADVICE
1. Read and follow these instructions taking note of any warnings. Keep these instructions for future reference.
2. Do not use the system or accessories near water.
3. Do not expose the system or accessories to rain or any other source of moisture.
4. Should the amplifier require cleaning only do so with a dry cloth.
5. Ensure that there is enough room around the Loop Amplifier for ventilation purposes.
6. Do not cover the ventilation holes of the amplifier with anything.
7. Do not place the Loop Amplifier close to sources of heat, such as radiators.
8. Place all connecting and power leads such that they are not a hazard or where they may become damaged.
9. Do not open casing of Loop Amplifier at any time; there are NO user serviceable parts.
10. Servicing must be referred to qualified service personnel.
11. Batteries should not be exposed to excessive heat such as sunshine or fire.
CAUTION:
Ensure mains power is disconnected BEFORE any audio connections are made to the Loop Amplifier.
To completely disconnect the system from the mains, remove the mains plug from the wall socket.
CAUTION: The top surface of the amplifier may become hot when operating this system continuously.
United Kingdom - connection to mains supply
This apparatus must be protected by a 3amp fuse if a 13amp(BS1363) plug is used. Be sure to replace the
fuse only with an identical approved type, as originally fitted, and to replace the fuse cover.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code :
Blue: Neutral
If you need to change the mains plug supplied, the colours of the wires in the mains lead of this apparatus
may not correspond with the coloured markings identifying the terminals in your plug. Proceed as follows:
The wire coloured BLUE must be connected to the terminal marked with the letter N or coloured BLACK. The
wire coloured BROWN must be connected to the terminal which is marked with the letter L or coloured RED.
DO NOT make any connection to the terminal which is marked with the letter E or coloured GREEN.

Important Safety Instructions

Do not touch the top surface during use or block the ventilation holes.
Brown: Live.
3