Operating The Timers - Rinnai Energysavers RHFE-309FT Operation And Installation Manual

Operating the timers

The timers can be programmed to operate for any two time periods in 24 hours. Before
operating the timer, the clock must be set and a timer start and finishing time must be
entered. The two timers operate in the same way.
To select the timer(s) to commence heating
1. Press the Set Times button and check the time shown on the digital display is correct. Press
the Set Times button again to stop the flashing on the timer indicator(s).
2. Check the ON and OFF times, for both timers if necessary.
3. Press the ON/OFF button to operate the heater without the Clock and Timer indicators
flashing. The ON indicator will glow green.
4. Select the desired temperature setting.
Press the Timer 1 and/or Timer 2 button(s). The timer indicator(s) will glow and the heater will
remain on standby until one hour prior to the time programmed into the selected Timer(s) is
reached. When this time is reached, the Timer indicator will flash and the heater will operate.
Set and forget operation
Your heater can be operated to alternate between the timers automatically during cold weather
by selecting Timer 1 and Timer 2 buttons together. Both timer indicators will glow and the
appliance will remain on standby between the timer periods.
Power disruption
If there is a power failure (or if the unit is switched off at the wall) the system memory will
retain the Timer programs but the clock will stop at the time the power goes off. The clock will
restart when the power comes back on, but the time will be slow by the duration of the power
failure.
Rinnai New Zealand Energysaver
14 ®
RHFE-309FT and RHFE-559FT (01-10)
Operation and Installation Manual: