Makita MT560 Instruction Manual page 9

3
2
1
4
1. Hex bolt
2. Outer flange
3. Saw blade
4. Inner flange
1 2
3
1. Mounting shaft
2. Inner flange
3. 19mm marking
4. Saw blade
5. Outer flange
6. Hex bolt
To install the blade, follow the removal procedure in reverse.
004032
BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE
SECURELY.
004033
CAUTION:
6
• The inner flange has a 20 mm diameter on one side and
a 19 mm diameter on the other. The side with 19 mm
diameter is marked by "19". Use the correct side for the
hole diameter of the blade you intend to use. Mounting
5
the blade on the wrong side can result in the dangerous
4
vibration.
Side grip (auxiliary handle) (Accessory)
004034
Align the hole in the grip holder with the hole in the blade
case (upper blade guard) and secure the grip holder onto the
blade case using the screw as shown in the figure. Securely
screw the side grip clockwise into the hole in the grip holder.
Hex wrench storage
004035
When not in use, store the hex wrench as shown in the figure
to keep it from being lost.
9