GE JVM1851 Owner's Manual page 35

Replacing the lightbulbs.
Remove
screw
Screws
Cooktop Light/Night Light
On models JVM1850 and JVM1851, replace the
burned-out bulb with a 40-watt incandescent bulb
(WB36X10003), available from your GE supplier.
On model JVM1860, replace the burned-out bulb with
a 20-watt halogen bulb (WB36X10213), available from
your GE supplier.
To replace the bulb(s), first disconnect the
1
power at the main fuse or circuit breaker panel
or pull the plug.
Remove the screw at the right edge of the
2
light cover and push on the left edge of the
cover to open.
Be sure the bulb(s) to be replaced are cool
3
before removing. After breaking the adhesive
seal, remove the bulb by gently turning.
Replace the screw. Connect electrical power
4
to the oven.
Oven Light
Replace the burned-out bulb with a 20-watt halogen
bulb (WB36X10213), available from your GE supplier.
To replace the oven light, first disconnect the
1
power at the main fuse or circuit breaker panel
or pull the plug.
Remove the top grille by taking out the 3 screws
2
that hold it in place and sliding the grille to the
left (opening the door makes grille removal
easier).
Next, remove the screw located above the door
3
near the center of the oven that secures the
light housing.
Replace the grille and screws. Connect electrical
4
power to the oven.
www.geappliancescanada.com
35