Using Sxa360'S As Floor Monitors - Electro-Voice SxA360 Owner's Manual

Using SxA360's as Floor Monitors

• The SxA360 is perfect for use as a powered floor monitor.
• The F200 adapters are necessary to convert the Sxa360 into a monitor and are shipped with the speaker.
To install the adapters, simply insert them into the speaker (see Figure 2 below). The F200 adapters can
be easily removed by pulling in the opposite direction.
• The F200 Monitor Foot kit contains two plastic feet.
• The F200 is used with any 12-inch Sx or SxA speaker enclosures.
• Insert the feet firmly into the holes in the rear cabinet (see Figure 2).
• Remove the F200 monitor feet by pulling in the opposite direction.
Figure 2:
Installing the F200 Monitor Foot on the SxA360 Speaker
Caution: The F200 monitor feet protrude from the enclosure. Care should be taken when moving the
enclosure, since damage to the feet or the enclosure might occur if the system is dropped or slid
across a rough surface. It is recommended that the feet be removed for transport.
7