Rand-Kar X-AIR HANUMAN 602T AP User Manual page 30

Walk back along the fuselage and check:
2 0 0 8 , o c t o b e r , 1 7
- linkage on elevator bellcrank
- fastenings of stab fitting cables
- clevises on pushtubes to elevator bellcranks
- elevator attach fittings
- hinges of elevator and rudder
- condition of fabric on tail surfaces
- shackles on rudder cables
- fastenings of rear fuselage section
Walk over to the right side and check:
- elevator hinge on right side
- Stab cables fastenings
- general condition of tail surfaces
Move forward and check:
- rudder cables are crossed
- fuselage tubes fittings
- the wheel fastenings and the tyre pressure
Move along trailing edge and check:
- trailing edge fastening
- upper and lower rear strut fitting
- aileron fittings and aileron controls
- flaps fittings and flaps controls
- compression tubes and drag cables fittings
- Trailing edge fittings and fabric along
- check safe and firm positioning of wing tip fairing
Move to the cabin along leading edge
- fastenings of leading edge tube
- the wheel fastenings and the tyre pressure
- the upper and lower wing strut fastenings
- Jury struts fastening
- along the length of the wing struts
- the condition of the wing leading edge
- fastenings of compression tubes and drag cables inside the wing sail
In the cockpit, check:
- proper condition of seat bolts
- shackle safetied
- condition and tension of aileron cables and linkages
- rudder cables (must cross)
- tank vents open and tanks properly attached
- Fittings and conditions of all cabin tubes
- throttle cable at throttle lever and normal operation of throttle
- choke, gas filter, gas line, and electric pump if fitted
- airspeed indicator operation, AGL or MSL setting on altimeter
- fuel level
- well work of flaps, ailerons, rudder and elevator controls