SS2 - - - - DIRECT DIRECT DIRECT DIRECT POWER POWER POWER POWER LIGHTING LIGHTING LIGHTING LIGHTING MANUAL MANUAL MANUAL MANUAL Coloronix, Inc. 5461 West Jefferson Boulevard Los Angeles, California 90016 (323) 677-4242 http://www.rgbw.com...
Page 2
According to copyright laws, this manual may not be copied—partially, or wholly— without the written consent of Coloronix, Inc. Despite full effort to avoid any clerical or printing inaccuracies, Coloronix, inc. accepts no responsibility for any such inaccuracies to be found in this manual.
4x4 inch electrical junction box rated for the application (optional) Controller (DMX512 compatible) Proper mounting bolts, washers and lock washers to secure the fixture to the mounting surface. Page 4 of 13 - Coloronix SS2 Direct Power Lighting Manual V.2.0.1...
L70 Life: 35,000 Hours. Temperature Rating: 14°F - 104°F Ambient. LED Die Colors: Red (620-635nm) Green (520-535nm) Blue (450-465nm) Neutral White (5000k) Safety: Complies to UL1598 and ANSI/UL 8750. Page 5 of 13 - Coloronix SS2 Direct Power Lighting Manual V.2.0.1...
Quick Step-by-Step Instructions To successfully install RGBW Recessed Lighting, the steps are: 1. Mounting and alignment of fixture 2. AC power connections 3. DMX connections 4. Ready to go. Page 6 of 13 - Coloronix SS2 Direct Power Lighting Manual V.2.0.1...
Cool White 0-255 Green 0-255 Blue 0-255 White Lock Function: If MENU is IDLE for 20 seconds, MENU will lock. Hold “MODE” and “DOWN” button to release lock. Page 7 of 13 - Coloronix SS2 Direct Power Lighting Manual V.2.0.1...
(long duration on, then quick jump off and on) Green Blue (long duration on, then quick jump off and on) White (long duration on, then quick jump off and on) Page 8 of 13 - Coloronix SS2 Direct Power Lighting Manual V.2.0.1...
Then, replace the cover. NOTE: Supply lead wires should not be connected to a dimmer of any sort. Maximum power connection should not exceed 9 units at 120V. Page 9 of 13 - Coloronix SS2 Direct Power Lighting Manual V.2.0.1...
B. In order that they may be easily accessed once construction is complete, secure data cables in the immediate proximity of the fixtures. Note: To avoid signal transmission problems and interference, it is always advisable to connect to a DMX signal terminator. Page 10 of 13 - Coloronix SS2 Direct Power Lighting Manual V.2.0.1...
Maintenance Maintenance Maintenance Coloronix recommends periodic cleaning of the heat sink and lens. Over time these components can become dirty or full of debris. This can result in lack of cooling or can limit the capabilities of the fixture. Lens Maintenance Clean the front Lexan®...
If output is less than normal, check if: Environment temperature may be in excess of 40°C/105°F. Lens may be damaged or dirty. DMX control or RGBW channels may be set at low level. Page 12 of 13 - Coloronix SS2 Direct Power Lighting Manual V.2.0.1...
The length, limitation, or cancellation of a warranty, whether incidental or resulting from use, may not apply to individuals in certain states. This warranty is the only warranty, written or verbal, accepted by Coloronix, Inc. The rights of the consumer herein may be different from state to state.
Need help?
Do you have a question about the SS2 and is the answer not in the manual?
Questions and answers