GE AEM24 Series Owner's Manual And Installation Instructions page 11

Installation Instructions
[] PREPARE THE CASE (continues)
rE] Attach the side retainers to the case using 6 type
A screws.
[_] PREPARE THE WINDOW AND INSTALL
THE CASE
r_ cut the window sash seal to the proper length.
Peel off the backing and attach the seal to the
underside of the window sash.
[_Open the window and mark the center of the
window sill.
r_ carefully slide the case into the window and
center the case. Lower the window behind
the top mounting rail. Pull the bottom of the
case forward so that the bottom mounting rail
is tight against the back of the window stool.
Haunt the case to the window sill using 2 type
C screws. Drill pilot holes, if necessary.
Stool
2 type C screws
ITIPREPARE THE WINDOW AND INSTALL
THE CASE (continues)
r_ Assemble the V-support and V-support bracket
with Type F nut and bolt
Type Ebolt
nut
Left
B]
E]
Sillangle
bracket ----_@ a_
V-support Type
F bolt and nut
Right
Position the V-supports
on the case bottom so 11
that they will be near the
1
outside wall. Attach a
V-support to each side of
the bottom of the case with
Type E bolts, 2 for each
support.
Adjust sill angle brackets to rest on sill.
ipport
_-_Sill
Bracket
J'_ Extend the left and right accordion panels
to the vertical window sashes. Drill pilot holes and
attach the top corners with 2 type C screws.
TypeC
screw
screw
11