Makita 4340CT Instruction Manual page 8

1
2
1. Base
2. Bolt
3. Hex wrench
2
1
5
6
4
1. Graduations
2. Bevel slot
3. Base
4. V-notch
5. Bolt
6. Gear housing
1
2
1. Base
2. Bolt
3. Hex wrench
8
Bevel cutting
001914
CAUTION:
• Always be sure that the tool is switched off and unplugged before tilting
the tool base.
With the tool base tilted, you can make bevel cuts at any angle between 0°
and 45° (left or right).
Loosen the bolt on the back of the base with the hex wrench. Move the base
001915
so that the bolt is positioned in the center of the bevel slot in the base.
3
Tilt the base until the desired bevel angle is obtained. The V-notch of the gear
001916
housing indicates the bevel angle by graduations. Then tighten the bolt firmly
3
to secure the base.
Front flush cuts
001917
Loosen the bolt on the back of the tool base with the hex wrench, then move
3
the tool base all the way back. Then tighten the bolt to secure the tool base.