Advertisement
No tools required
for ass_bly.
Attach
handle
to vacuum
Locate the vacuum
base and the handle. Stand
the vacuum
base upright
and slide the handle
into the opening
at the top of the vacuum
base.
The handle will click into place at the highest
height
setting.
NOTE: The handle has two height settings.
To lower or raise the handle, push the handle
height adjustment
button (designated
by the
corresponding
icon pictured
below) and slide
the handle up or down until it locks into place.
AWARNING
Do notplug inyour v acuum cleaner until
you are familiar withall i nstructions
and
0peBting pr0cedure_
AWARNING
Plastic filmcan be dangerous,
To avoid
danger ofsuffocation,
keep away f rom
babies and children.
Attach
vacuum
hose and tools
1. Attach
the Twist n' Snap
TM
hose by lining up
the tabs on the hose cuff with the corresponding
notches
on the back of the vacuum.
Twist the
hose cuff clockwise
to lock the hose into place.
2. Slide the end of the hose wand into the hose
wand base and fold the hose over the upper
hose wrap.
NOTE: The powerfoot
will not operate effective-
ly unless the hose is firmly attached to the base.
3. Slide the crevice
tool/extension
wand holder
onto
the lower mount
on the back of the
vacuum
as shown.
Snap the crevice
tool
into
the tool
holder.
4. Slide the specialty
tool holder onto the upper
mount
on the back of the vacuum
as shown.
Snap the TurboBrush
Tool into the tool holder.
5. Wrap the power cord around
the cord
wrap clips.
Power
switch/brush
switch
The power switch
is located
just below the handle
on the front of the detachable
pod. Push the
switch once to turn the vacuum
on and again to
turn the vacuum
off when cleaning
is complete.
The brush roll power switch
is located just below
the handle on the front of the detachable
pod
above the power switch. This switch
turns the
rotating
brush power on and off. The switch will
glow when activated.
NOTE; The brash roll power will automatically
shut off whenever
the vacuum
is locked in
its upright position. The switch will continue
to glow if left on in the upright position or if
the pod is detached
from the vacuum base,
although
the brush will not reactivate
until the
pod is attached
and the vacuum is detented.
power
ACAUTION
Before using y0ur v acuum, make sure that
thedirtcontainer isinlocked p osition and
thatall f ilters (pre-m0t0r and p0st-m0t0r)
areinplace. Do notoperate your v acuum
without these filters.
www.BISSELL.(
brush
Advertisement
