Advertisement
Maintainin_l
the TurboBrush
Tool and Pet TurboEraser
Tool
The TurboBrush
Tool should
be checked
regularly
for clogs or debris wrapping
around the brush.
Select models
include a Pet TurboEraser
Tool that
follows the same maintenance
instructions.
1. Unplug
the vacuum
from electrical
outlet.
2. If a clog is present
or debris
is visible, twist
the grey collar counterclockwise
to remove
the
faceplate
and clear any obstructions.
3. To clean debris
from the brush, remove
the
brush from the drive belt and clean debris.
4. Reposition
the drive belt on the brush.
Please ends of the brush in slots on sides.
5. Reposition
the faceplate
and secure by
twisting
the grey collar clockwise.
Clearin_l
clovis
Low suction
or poor pickup
may be due to
a clog in the vacuum
cleaner. If you notice a
change
in the sound of the motor
or a reduction
in the spinning
action,
check for clogs.
1. Unplug
cleaner from electrical
outlet.
2. Empty dirt container.
3. Check upper tank for build up or clogs.
4. Remove the secondary
cyclone
and check the
suction
inlet for a clog.
5. Grasp the hose grip and lift to separate
from
the suction
opening.
Check for a clog in the base
or the hose.
6. Release the Twist n' Snap hose from the
vacuum
by turning
to the left. Straighten
the
hose and unclog
with a long, narrow
object
such as a broomstick.
7. If the low suction
persists,
follow the
instructions
for checking
the rotating
brush on page 10 and inspect
the air
passageway
for obstructions.
8. Check all filters for clogs, per instructions
on page 9.
7,
Air Passageway
www.BISSELL.com
_r
8OO.237.7691
12
Advertisement
