Advertisement
Before Setting Oven Controls
Oven
Vent Location
The oven vent is located
under the left side of the control
panel.
When
the oven is on, warm
air passes through
this vent. This
venting
is necessary
for proper
air circulation
in the oven and
good
baking
results. Do not block
oven vent. Steam
or moisture
may appear
near the oven vent; this is normal.
oven vent
location
Removing, Replacing, and Arranging Oven
Racks
To Arrange
- Always
arrange
the oven racks when the oven is
cool (prior
to operating
the oven).
To Remove - Pull the oven rack straight
forward
until it reaches
the stop position.
Lift up front of oven rack slightly
and slide out.
To Replace
- Place the oven rack on the rack guides
on both
sides of oven walls.
Tilt the front of oven rack upward
slightly
and slide the oven rack back into place.
Be sure oven racks are
level before
using.
{
Figure 19: Do not block
oven vent location
_
Protective
Liners --
Do not use aluminum
foil to
line the oven bottom.
Only use aluminum
foil as recommended
in this manual.
Improper
installation
of these liners may result in
risk of electric
shock or fire.
Always
use pot holders or oven mitts when using
the oven. When
cooking,
the oven interior
and exterior,
as well
as the oven racks, will become
very hot which can cause burns.
__
_
0ffs_et
"
bottom
0ven rack __
Figure 20:
Oven rack types
Oven
Rack Descriptions
•
Flat oven racks (or the flat
handle
oven rack)
may be used
for most cooking
needs and may be placed
in most oven
rack positions.
The offset
oven rack (some models)
provides
additional
stepdown
positions
from
the standard
flat
rack design.
The
offset
design
positions
the base of the rack about
1/2 of a
rack position
lower than the flat
rack and may be used in
most oven rack positions.
•
To maximize
oven cooking
space,
place the bottom
oven
rack (some models)
in the lowest rack position
for baking
or
roasting
large
cuts of meat.
15
Advertisement
