Advertisement
Available languages
Available languages
Lay one of the wing tables upside down, as shown. Lift up one of the support bars from the wing
table support brackets, and fasten it to a vertical bar as shown, using a 43 mm pin and a cotter pin.
Once the cotter pin is in place, bend the legs at right angles to lock it into place. Repeat for the other
support bar.
Insert the side table shaft through the oblong hole at the back end of the wing table, through the
holes in the support brackets and vertical bars. Once the shaft is fully inserted into the wing table,
rotate it so that the short right angled end is no longer aligned with the oblong hole. It will stay in
place.
Repeat these steps for the other wing table.
Vertical Bar
/43
mm Pin
¢"
Cotter Pin
_J
Bend Legs of Cotter Pin
-Side Table Shaft
Support Bar
Front
ii
Install Wing Tables
Loosen the 4 screws (as shown) on each side of grill head 4 to 6 turns.
Slide the slots in each vertical bar over the loosened screws. Make sure the wing surface is flush with
the control panel, then tighten the 4 loosened screws with a long screwdriver that has at least a 7
inch long shaft.
Note: Attach each wing so that the rounded edge faces front.
Slide slots over screws
Loosen the four screws
@
22
Advertisement
