Unassembled Parts; Assembly/Pre-Operation; Tools Required For Assembly; To Remove Tractor From Carton - Craftsman 917.20391 Operator's Manual

Keys
d:::
............
-::::::: o
II (!) Oit Drain Tube
............... 9,,I
_-_) (1) Quick
Key(s)
Connect
Slope Sheet
Your new tractor has been assembled at the factory with the exception of those parts left
unassembted for shipping purposes.
TOOLS REQUIRED FOR ASSEMBLY J
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) 1/2" wrench Tire pressure gauge
(2) 7/16" wrenches Utility knife LABEL
Pliers
When right or left hand is mentioned in this
manual, it means when you are inthe operating
position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
Remove all accessible loose parts and
parts cartons from carton.
* Cut along dotted lines on all four panels
of carton. Remove end panels and lay
side panels flat.
* Check for any additional loose parts or
cartons and remove.
BEFORE REMOVING TRACTOR
FROM SKID
TO CHECK BATTERY
1. Lift hood to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY" in Maintenance section of this
manual for charging instructions).
For battery and battery cable installation
see "REPLACING BATTERY" in the
"Service and Adjustments" section in this
manual.
ADJUST SEAT
1. Sit in seat.
2. Lift up adjustment lever (A) and slide seat
until a comfortable position is reached
which allows you to press clutch/brake
pedal all the way down.
3. Release lever to lock seat in position.