Advertisement
Complete
Installation:
1.Insert window
sash seal behind
the top o fthe lower window
sash and a gainst
the glass of t he upper window
(FIG.15).
2.Place the window-lock
bracket
on top o flower window
and a gainst
upper
window
sash on right side ofthe w indow
(FIG,15).
3.Use a 3/32" drill bit todrill starter holes through
the holes in the bracket
into
the w indow
sash (FIG.15).
4.Attach the window
lock-bracket
to the window
sash with t wo # 10 X 1/2"
round-head
screws
tosecure
window
inplace (FIG.15).
5.Insert air c onditioner
into c abinet
(FIG.16).
6.Reconnect
electronics
plug i fpresent,
Insert front tabs offront panel into t op of
cabinet
and s wing front into p lace (FIG.17A).
7.Attach bottom
front ofpanel with f ront panel screws
(FIG.17B).
8.Plug into a grounded
3prong outlet,
9.Press RESET
on the power
supply
cord,
FIG.16
FIG.17A
electronics
plug
Through-the-Wall
Cabinet Installation:
Option l--wood,
metal or plastic molding:
FIG.15
B
C A
D
A. Window lock bracket
B. Upper window glass
FIG.17B
C. Window sash seal
D. #10Xl/2"
round-head
_
screws
iNN
When using a wood, metal or plastic molding, the wood frame should line up with the inside wall as shown FIG.18.
Option
2--Plastered
wall
with
no molding:
If the plastered wall is to be flush with the cabinet and no molding is used, the wood frame must be set 1/2" (13ram).
into the inside wall FIG.19.
FIG.18 A B C
AB
C
FIG.19
A. Molding
C. Wood frame
A. Plastered wall
B. Inside wall
D. Louvers
B. Inside wall
Install
Wood
Frame:
t. Construct
the wood frame. See FIG.20 for dimensions.
C. Wood frame
D. Louvers
FIG.20
C
t
A. 16" (40.6 cm)
C
B. 22-5/8" (57.5 cm)
C. Wood thickness
D. 2-1/2" (6.4 cm) minimum to
6-1/2"(16.5
cm) maxtmum
2. Measure the outside width and height of frame to determine wall opening dimensions. The wall opening
measurements
should be :
Width : 22-5/8" (57.5 cm) plus twice thickness of wood used to build frame.
Height: 16" (40.6 cm) plus twice thickness of wood used to build frame.
Depth : 2-1/2" (6.4 cm) minimum to 6-1/2" (16.5 cm) maximum.
3. Cut the opening through the wall. Remove and save insulation.
4. Apply the wood preservative
to the outside exposed surface.
5. Insert the frame in the wall opening. Square and level frame.
6. Attach frame securely to the wall.
Advertisement
