ALWAYS MAKE SURE POWER IS OFF
BEFORE WIRING COMPRESSOR
2
Remove panels
and electrical cover
4
Put cover back on electric panel before checking for proper rotation. If
rotation is incorrect swap wires in position 1 & 3 to change the rotation.
Once rotation is correct place all panels back on compressor
28
compressor diagram
Place incoming power
wires through wiring
port on the bottom of
the unit
1
Place 1 of the
incoming power
lines under the
starter screw
shown
3
Place ground wire
under washer
Place 2nd incoming
power wire in position 2
on compressor motor
contact
Place 2nd
incoming
power wire in
position 2
on compressor
motor contact