Frigidaire CGEF3030PWA Installation Instructions Manual

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER.
iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.
READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.
Clearances and Dimensions
1. Provide adequate clearances between the range and adjacent combustible surfaces.
2. LocationmCheck location where the ran_ will be installed. Check for proper electrical supply, and the stability
of the floor.
3. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must
be solid and level.
FRONT I__ ........ ............ ......
" (762r'nr'n) (7.6?2mm) _
Minimum
Minimum to walt
Minimum to
/
on eitherside of 1"-1_
range above (25 mm)
36"(914 mm)
height.
-- o o •
18" cabinets on
(457 ram) either side of
,_ range.
4---
,
SIDE
VIEW
I'_-- 13" "_'I
330 mm
Maximum depth
for cabinets
above range top.
30" ,,
(762 mint "-_0 (O ram) clearance below cooking top and at rear of range.
RANGE _._ 30"
OVERALL (762 ram)
DIMENSIONS ,, _iii_
25_ 3/4"
(654 ram)
48"
(1219 mm)
Maximum
T
36 ± 1/8"
(940 ram) (3 ram)
Centertine of
range
2_5/8" (67 mm) for models
equipped with warmer drawers
3_1/2" (89 ram) for models
equipped with storage drawers
I 1
All dimensions for electrical outlet location
are maximum.
i
Dashed cubed area
shows where the electrical outlet must be
installed
for flush to the wall installation.
Wall
Edge
*30" (762 mm) MINIMUM CLEARANCE BETWEEN THE TOP OF THE COOKING SURFACEAND THE BOTTOM OFAN UNPROTECTED
WOOD OR METAL CABINET; OR 24" (610 mm) MINIMUM WHEN BOTTOM OF WOOD OR METAL CABINET IS PROTECTED BY NOT
LESS THAN 1/4" (6 mm) FLAME RETARDANT MILLBOARD COVERED WITH NOT LESS THAN NO. 28 MSG SHEET STEEL, 0.015"
(0.4 mm) STAINLESS STEEL, 0.024" (0.6 mm)ALUMINUM OR 0.020" (0.5 mm) COPPER. 0" (0 mm) CLEARANCE IS THE MINIMUM FOR
THE REAR OF THE RANGE. FOLLOWALL DIMENSION REQUIREMENTS PROVIDED ABOVE TO PREVENT PROPERTY DAMAGE,
POTENTIAL FIRE HAZARD, AND INCORRECT COUNTERTOPAND CABINET CUTS.
TO ELIMINATE THE RISK OF BURNS OR FIRE BY REACHING OVER HEATED SURFACE UNITS, CABINET STORAGE SPACE
LOCATED ABOVE THE SURFACE UNITS SHOULD BE AVOIDED. IF CABINET STORAGE IS TO BE PROVIDED, THE RISK CAN
BE REDUCED BY INSTALLING A RANGE HOOD THAT PROJECTS HORIZONTALLY A MINIMUM OF 5" (127 turn) BEYOND THE
BOTTOM OF THE CABINETS.
English- Pages1-4
PIN 316259203 REV C (1409} Fran_ais- Pages5-8