Advertisement
Installing or removing driver bit
CAUTION :
Always be sure that the tool is switched off and the battery cartridge
i s
removed before
installing or removing the bit.
Slide the sleeve toward the motor and in-
sert the bit into the sleeve as far as it will
go. Then release the sleeve to secure the
bit.
NOTE
:
I f the bit is not inserted deep enough into the sleeve, the
sleeve
will not return to
i t s
original position and the bit will not be secured. In this
case,
try re-inserting the bit
according to the instructions above.
To remove the bit, slide the sleeve toward the motor and pull the bit out firmly.
Holding tool
Hold the tool as shown in the figure.
When drilling a large diameter hole, hold
the tool firmly with both hands.
CAUTION
:
Before inserting the battery cartridge into the tool, always check to see that the trigger
switch actuates properly and returns to the "OFF" position when released.
7
Advertisement
