Advertisement
Available languages
Available languages
Do not, underany circumstances, cut or removethe
third (ground)prongfrom the power cord.
Disconnect electrical supply cordfrom
wallreceptacle beforeservicing c ooktop.
Preferred
Method
Grounding type
wall receptacle
not, under any
circumstances,
cut,
remove, or bypass
the grounding
prong.
Power supply cord with
3-prong grounding plug.
Figure 9
Model
and
Serial
Number
Location
The serial plate is located on the underside of the
cooktop (see Figure 10).
When ordering parts for or making inquires about your
range, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
of your cooktop.
Your serial plate also tells you the rating of the burners,
the type of fuel and the pressure the cooktop was
adjusted for when it left the factory.
rest level. Refer to Figs. 12 & 13 for correct and incorrect
burner cap placement. Once in place, you may check the
fit by gently sliding the burner cap from side to side (Fig.
14) to be sure it is centered and firmly seated. When the
burner cap lip makes contact inside the center of the
burner head you will be able to feel it. Please note that
the burner cap should NOT move off the center of the
burner head when sliding from side to side. NOTE: There
are no burner adjustments necessary on this cooktop.
Burner Cap
Burner Head
"_
_
Burner
Cap Lip
Fig. 11
Correct Burner Cap
_
Incorrect Burner Cap
Placement-
Fig. 12
_
Placement-
Fig. 13
Serial plate is
located under
the burner box.
Figure 10
Check Operation
Refer to the Use and Care Guide packaged with the
cooktop for operating instructions and for care and
cleaning of your cooktop.
Do not touch the burners. They may be hot enough to
cause burns.
1. Install Burner Caps
This cooktop is equipped with sealed burners. All pieces
are at their place. Take note where they are. Remove
all packaging material. Make sure the burner caps are
properly aligned and leveled. The burner cap lip (See Fig.
11) should fit snug into the center of burner head and
Fig. 14
2. Place the Grates on the cooktop
Be sure they are correctly located inside the stainless steel
surface.
ATTENTION:Do not slide the grates on the cooktop, doing
so can damage the surface.
36" Cooktop ONLY:Be surethe grates are correctly placed on
the cooktop as shown below. Heat shields must be beside the
knobs.
Fig. 15
Heat shields
Advertisement
