Advertisement
Available languages
Available languages
Typical Under
Oven
Counter
Installation
of an Electric Built-in
with a Cooktop
Mounted
Above
All mounting
hardware
must be
used to secure the built-in oven to
the cabinets. Refer to the built-in
oven installation instructions.
Junction box must
be located approx.
3" to the left of
the built-in oven
cutout.
This cooktop may
be installed over
certain built-in elec-
tric oven models.
Side filler panels are necessary to
isolate the unit from adjoining
cabinets. Panel height should allow
for installation of approved cooktop
models. See "Typical Gas Cooktop
Installation Over an Electric Built-in
Oven Installed Under the Counter" on
next page.
208/240 Volt
grounded junction
box for built-in oven.
36"
(91.4 cm)
Min.
Use 3/4" (1.9 cm)
plywood, installed
on two runners,
flush with toe plate.
Must be capable of
supporting 200 Ibs.
Cut an opening in wood base minimum 4"
(10.2 cm) x 4" (10.2 cm) to route armored
cable to junction box.
4 1/2" (11.4 cm)
Max.*
If no cooktop is installed
directly over the oven unit,
5" (12.7 cm) maximum is
allowed.
(76.2 cm)
(71.8 cm)
Figure 3
(73.3 cm)
(72.4 cm)
73.7 cm
(61 cm)
Advertisement
