VTech CS6648-3 User Manual page 50

The answering Make sure the answering
system does system is on. When the
not record answering system is on,
messages. ANS ON should display
on the handset and the
telephone base.
When the answering
machine memory is full,
it does not record new
messages until some old
messages are deleted.
If you subscribe to
voicemail service, change
the number of rings so
that your answering
system answers before
your voicemail service
answers. To determine how
many rings activate your
voicemail service, contact
your telephone service
provider.
The answering Make sure you have set
system does the date and time. See
not announce
Configure your telephone
the correct day
section.
of the week
for recorded
messages time
stamp.
The messages Press VOL+ on the
on the handset or p/VOLUME
answering on the telephone base
system are to increase the listening
very difficult to volume.
hear.
The messages If a caller leaves a very
on the long message, part of
answering it may be lost when
system are the answering system
incomplete. disconnects the call after
the preset recording time.
If the memory on the
answering system
becomes full during a
message, the answering
system stops recording
and disconnects the call.
If the caller's voice is very
soft, the answering system
may stop recording and
disconnect the call.
The answering
system does
not respond
to remote
commands.
I subscribe to a
nontraditional
telephone
service that
uses my
computer
to establish
connections,
and my
telephone
doesn't work.
I accidentally
set my LCD
language to
Spanish or
French, and
I don't know
how to change
it back to
English.
43
Make sure you enter the
correct remote access
code.
Make sure you are
calling from a touch-tone
telephone. When dialing a
number, there should be
tones. If there are clicks,
then it is not a touch-tone
telephone and cannot
activate the answering
system.
The answering system
may not detect the remote
access code when
your announcement is
playing. Wait until the
announcement is over
before entering the code.
Make sure your computer
is powered on, and
your Internet is working
properly.
Make sure to plug your
USB telephone adapter
into a dedicated USB port
on your computer. Do not
plug into a multiple port
USB hub (USB splitter) that
is not powered.
In a few rare instances, the
USB port on your computer
may not have enough
power. In these instances,
try using a USB hub with
its own external power
supply.
If you are using a firewall,
it may prevent access
to your nontraditional
telephone service. Contact
your service provider for
more information.
While the handset is not in
use, press MENU and then
enter 364# to change the
handset LCD language
back to English.