LG WT4970CW Owner's Manual page 28

28 MA NTENANCE
MAINTENANCE
Cleaning the Water Inlet Filters
if the washer detects that water is not entering the
dispenser, an error message will show on the display, If
you live in an area with hard water, this may be caused by
clogged inlet filters_
Care in cold climates
1 Turn off both: water taps completeiy, Unscrew the hot and
cold water lines from the back of the washer,
2
Carefully remove the filters from the water inlets, and
soak them in white vinegar or a lime scale remover, Rinse
thoroughly before reinstalling. Press the filters back into
place and reattach the water lines. Do NOT operate the
washer without the inlet filters
Inlet
WA R N I N G ..................................................................................................................................
° Unplug the power _rd and turn off the fau_ before
cleaning. Failure to do so may cause electric shock.
• Do not use the washing machine without the inlet
filters, If you use the washing machine without the
inlet filters it will cause leaks and malfunction
• If you use the washing machine in an area with hard
water, the inlet filter may clog due to lime buildup,
Contact your nearest LG customer service center if the
inlet filter is not clean or is missing.
t
2
Turn off the faucets connected with the water lines,
Pour hot water on the frozen faucets to thaw the water
lines and pull them out.
3
4
Connect the water lines with the water inlets of the
washing machine and faucets.
See page 14, Connecting the water lines for details.
5 Turn on the faucets,
6 Press @,
_ to RINSE + SPIN.
7
Press
8 Press (_
Verify the water fills properly.
Immerse the water lines in hot water to thaw them,
1
Pour hot water in the washer tub and close the lid.
o Leave it for 10 minutes.
2 Press_ after 10 minutes.
_'_) to SPIN ONLY.
3
Press
4
Press @.
- Check if the water drains.