Connecting Your Vcr To The Tv - Samsung SV-7000W Owner's Instructions Manual

00408A SV-7000W-GB1 9/7/99 1:43 AM

Connecting Your VCR to the TV

GB
TV
2
TV
3
OUT 2 OUT 1
R
AUDIO
L
VIDEO
5
LINE 2 IN
R - AUDIO - L VIDEO
2 1
OUT OUT
R
AUDIO
EURO AV
L
VIDEO
6
TV
12
Page 12
To receive television programmes from an air or cable television
network, a signal must be received from one of the following sources.
1
2
3
4
5
LINE 2 IN
R - AUDIO - L VIDEO
6
EURO AV
7
TV
* NOTICE:
An outdoor aerial.
An indoor aerial.
A cable television network.
Make sure that both the television and the VCR are
switched off before connecting the cables.
Remove the aerial or network input cable from the television.
Connect this cable to the 75Ω coaxial socket marked
rear of your VCR.
Plug the coaxial cable supplied into the
Plug the other end of the coaxial cable into the connector
previously used for the aerial on the television.
Connect one end of the RCA cable supplied to the output socket
(OUTPUT1 or OUTPUT2) on the rear of the VCR, if your television
is equipped with this type of connection.
Respect the colour coding of the Audio and Video In/Out
cable.
Connect one end of the SCART cable to the EURO AV socket on
the rear of the VCR, if your television is equipped with this type of
connection.
Plug the other end (of the RCA cable or SCART cable) into the
appropriate connector on the television.
Regardless of the type of connection chosen, you must
always connect the coaxial cable supplied. Otherwise, no
picture will be visible on the screen when the VCR is
switched off.
Make sure that both the television and the VCR are
switched off before connecting the cables.
You can select the coaxial cable using the RF Adapter
according to your Antenna socket.
[NTSC/PAL-M Region]
on the
socket on your VCR.
TV