Broan 153623 Instructions Manual page 3

7. Install mounting brackets.
iNSTALLATiON ACCESS
ROD HOLE
#
CONTROL
BOX
iNSERT
SCREWS
HERE
"_"_MOUNTiNG
BRACKET
FRONT
MOUNTING
HOLE
SEE
STEP 8.
Insert bent end of installation rod into access hole in housing.
L
Choose the mounting bracket with the center hole. Hang the
bracket from the rod, through this center hole, as shown. Pull
bracket up between cabinet and housing.
#8-18 x 1"
I
iNSERT
SCREWS
HERE i
Hold mounting bracket in place with rod.Two sets of screws are
provided. Use short screws for flush bottom cabinets or long
screws for recessed bottom cabinets. Insert two (2) screws
through housing and into mounting bracket. Do not tighten
screws completely.
Insert two (2) screws, short or long as appropriate, through
control box and into other mounting bracket. Do not tighten
screws completely.
8. Secure hood to cabinet.
9.
10.
PLASTIC CAP #8-18 x 1/2"
Align hood with sides and front edge of cabinet.Tighten screws
in each mounting bracket. Place plastic caps (provided) over
the ends of these screws from inside of cabinet.
Install two (2) additional screws into cabinet bottom, through
holes along the front edge of hood (See Step 7 illustration.)
Replace access cover.
Secure access cover with two (2) screws removed in step 5.
Mount cabinet on wall.
Make sure cabinet is securely attached to the wall and/or
adjoining cabinets. Mounted cabinet must be able to support
the added weight of the hood.
11. Attach ductwork and front trim.
#8-18 × 3/8"
3-1/4" x 10"
DUCTWORK'
Complete the ductwork from the hood, to the outside, using
a roof cap or elbow and wall cap.Tape all joints. Shelves may
be installed if trimmed to clear ductwork.
The front trim piece covers the gap between the housing and
the front edge of cabinet cut-out. Mount front trim to housing
with two (2) screws. (provided).