Installation; Introduction; Unpacking, Inspection, And Reshipment; Unpacking And Inspection - HP 5501B Operating And Service Manual

2 INSTALLATION

2-1.

Introduction

2-2. This section provides installation instructions for the HP5501B Laser Head including unpacking,
inspection and reshipment, installation, operating environment, and storage. Installation includes
information on grounding considerations, power supply requirements, power dissipation, fusing,
dimensions, and mounting and fixturing.
2-3.

Unpacking, Inspection, and Reshipment

2-4. The following paragraphs contain information for unpacking and inspection, warranty claims,
laser tube shipment, tagging for service, and packaging for reshipment.
TO AVOID HAZARDOUS ELECTRIC SHOCK, DO NOT PERFORM ELECTRI-
CAL TESTS WHEN THERE ARE SIGNS OF SHIPPING DAMAGE TO ANY
PORTION OF THE OUTER ENCLOSURE (COVERS, PANELS, CONNECTORS,
LEOS, ETC.).
2-5.

Unpacking and Inspection

2-6. Inspect the shipping container for damage. If the shipping container or cushioning material is
damaged, it should be kept until the contents of the shipment have been checked for
completeness and the instrument has been checked mechanically and electrically. Procedures
for checking electrical performance are given in
is mechanical damage or defect, or if the instrument or some component fails the performance
tests, notify the nearest Hewlett-Packard office. If the shipping container is damaged, or the
cushioning material shows signs of stress, notify the carrier as well as the Hewlett-Packard office.
Keep the shipping materials for the carrier's inspection. The HP office will arrange for repair or
replacement at HP's option without waiting for a claim settlement.
2-7.

Warranty Claims

2-8. Contact the nearest HP Sales and Support Office (see list at the end of this manual) for
information relative to warranty claims.
2-9.

Laser Tube Shipment

The laser tube assembly MUST be shipped in an approved HP container.
2-10. The laser tube assembly (HP Part Number 05501-60102) should only be shipped in an HP
container designed for that purpose. In addition, the container must indicate that the laser tube
contains magnetic material. If it is necessary to ship a laser tube, contact your nearest HP Sales
and Support Office for an approved container.
Section 4. If the contents are incomplete, if there
NOTE
HP5501B
Installation
2-1