Troubleshooting
Washer Symptom
Won't Spin
Stops/Pauses During Cycle
Won't Drain
Water Leaks
Is Noisy
Load Is Too Wet
22
©
Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
Possible Cause/Solution
•
Make sure lid is closed.
•
Press Start/Pause button to start washer.
•
Make sure power cord is plugged all the way into the electrical
outlet.
•
Check the laundry room fuse or circuit breaker.
•
The motor overload protector may have stopped the cycle. It
will reset itself and the display will show tp, St. Press the
Start/Pause button to resume cycle.
•
Broken drive belt. Call the service person.
•
Pauses are part of the washer's normal operation. The washer
will stop (pause) shortly before the wash and rinse spins.
•
Check the laundry room fuse or circuit breaker.
•
The motor overload protector may have stopped the cycle. It
will reset itself and the display will show tp, St. Press the
Start/Pause button to resume cycle.
•
Make sure drain hose is not kinked or twisted.
•
Make sure drain hose is not clogged.
•
Make sure drain receptacle is not clogged.
•
Refer to the Installation instructions to make sure that the
drain hose has been properly installed.
•
Check that fill hoses are properly installed on the faucets and
the washer's water mixing valve.
•
Check the condition of the fill hoses. Replace fill hoses every five
years.
•
Make sure drain receptacle is not clogged.
•
Check laundry room plumbing.
•
Check house water pressure. In cases of extremely low water
pressure, leaking may occur.
•
Laundry load may be oversudsing or overloaded. Use less deter-
gent (or low-sudsing detergent) and proper load sizes.
•
Wash load may be unbalanced. Open lid and redistribute the
load.
•
Make sure washer is level. Uneven leveling can cause vibration.
•
A newly installed washer may make a knocking sound if the ma-
chine has been in storage. The belt may have settled. Run wash-
er through 4-5 cycles to loosen belt. Washer operation will not
be affected.
•
Wash load may be unbalanced. Open lid and redistribute the
load.
•
Load is too small. Add items to make full load.
www.goedekers.com
Part No. 203183