Before You Begin - Weslo Pursuit 695i User Manual

BEFORE YOU BEGIN

Thank you for selecting the new WESLO PURSUIT
695i exercise cycle. The PURSUIT 695i blends
advanced engineering with contemporary styling to
provide you with a low-impact workout in the conve-
nience and privacy of your own home.
For your benefit, read this manual carefully before
you use the PURSUIT 695i. If you have additional
questions, please call our Customer Service
Department at 0345-089009. To help us assist you,
Towel Rack
Console
Seat
Seat Post
Seat Knob
Pedal
BACK
® please mention the product model number and serial
number when calling. The model number is
WLEX69071. The serial number can be found on a
decal attached to the PURSUIT 695i (see the front
cover of this manual for the location of the decal).
Before reading further, please look at the drawing
below and familiarize yourself with the parts that are
labeled.
Water Bottle Holder
(bottle not included)
Handlebars
Resistance Knob
FRONT
Front Wheels
RIGHT SIDE
4
HOW TO ADJUST THE RESISTANCE STRAP
If there is not enough pedaling resistance when the
resistance knob is turned to the highest setting, the
Resistance Strap (47) may need to be adjusted. To
adjust the Resistance Strap, the left side shield must
first be removed. Refer to the instructions at the left
and remove the left side shield.
Next, turn the
resistance knob
to the lowest
setting. Locate
and open the
33
47
Strap Buckle
(46). Grip the
end of the
Resistance
Strap (47) and 46
pull it up to
remove any
slack. While holding the end of the Resistance Strap,
fully close the Strap Buckle. Turn the Crank (33) for a
moment to make sure that there is not too much
resistance. When the Resistance Strap is properly
adjusted, reattach the left side shield and pedal.
HOW TO ADJUST THE BELT
The exercise cycle features a belt that must be kept
properly adjusted. If the belt causes excessive noise
or slips as you pedal, the belt should be checked. To
do this, the left side shield must first be removed.
Refer to the instructions on page 12 and remove the
left side shield.
Next, use an
adjustable
wrench to turn
the right pedal
counterclock-
wise and
remove it.
Remove the
right side
shield. Press
down on the
center of the
Belt (16) between the front and rear pulleys. There
should be from 1/4" to 1/2" of vertical movement
in the center of the Belt.
If the Belt (16)
is properly
adjusted, reat-
16
tach the side
shields and ped-
34
als. If the Belt
needs to be
adjusted, loosen
the M8 Washer
Nut (34) on
each side of the
Flywheel (39).
To tighten the Belt, turn the two M6 Nuts (37) clock-
wise; to loosen the Belt, turn the Nuts counterclock-
wise. Make sure that the Flywheel is straight and tight-
en the M8 Washer Nuts (34). Reattach the side shields
and pedals.
13
16
39
37