Assembly Instructions; Installing And Adjusting The J Handle; Installing The Cutting Attachment Shield - Ryobi 825r Operator's Manual

INSTALL AND ADJUST THE J-HANDLE
The J-handle comes installed on this unit. Use the
following information if you ever need to reinstall it.
1. Place the J-handle between the top and middle
clamp pieces (Fig. 1).
(4) Screws
Bottom Clamp
Nuts
2. While holding the three pieces together, install the four
(4) screws through the top clamp and into middle clamp.
NOTE: The holes in the top and middle clamp will line up
only when assembled correctly.
3. Place the clamps and the J-handle over the shaft
housing and onto the bottom clamp.
4. Hold each hex nut in the bottom clamp recess with a
finger. Start screws with a large Phillips screwdriver.
Do not tighten until you make the handle adjustment.
5. Slide the J-handle in or out until the arrow/white line on
the decal touches the clamp assembly (Fig. 2). You must
first loosen the screws if the handle is pre-installed.
Decal
6. While holding the unit in the operating position (Fig. 3),
position the J-handle to the location that provides you
the best grip.
7. Tighten the clamp screws evenly, until the J-handle
is secure.
8

ASSEMBLY INSTRUCTIONS

J-Handle
Top Clamp
Middle Clamp
Fig. 1
Fig. 2
Fig. 3
INSTALL THE CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting attachment
shield on your unit is not installed.
WARNING: To prevent serious personal
injury, never operate the trimmer without
the cutting attachment shield in place.
1. Place the cutting attachment shield onto the shaft
housing above the clamp assembly (Fig. 4).
2. Push the cutting attachment shield down to the top of
the cutting attachment assembly and then rotate the
cutting attachment shield until the screw holes align
and the guard fits into the recessed pocket (Fig. 5).
3. Install the screws with a Phillips screwdriver (Fig. 6).
Clamp
Assembly
Cutting
Attachment
Assembly
Recessed
Pocket
Shaft Housing
Fig. 4
Cutting Attachment
Shield
Fig. 5
(4) Screws
Fig. 6