12
APR100 Business Two-Way Radios Instruction Manual
Attaching the Antenna
1. Insert the antenna into the big screw
thread hole on top of the main unit.
2. Turn the antenna clockwise until it is
screwed down as shown in Figure 5 below.
Removing the Antenna
To
remove
the
counterclockwise as shown in Figure 5
below.
antenna,
turn
Antenna
Figure 5
AP R1
00
Copyright © 2015 RCA Communications Systems
Attaching/Removing the Belt Clip
1. Using a small screwdriver, remove the
screws from the back of the radio's chassis.
2. Align the belt clip's screw holes to the
radio's chassis. Turn the screw clockwise
into the belt clip's screw holes. See Figure
6 below.
it
3. To remove the belt clip, turn the screwdriver
counter-clockwise to loosen the screw. See
Figure 6 below.
Figure 6
Belt Clip