Trouble Shooting - Bush BUCL6082 Installation & User's Instructions

Trouble Shooting

If your larder is not working properly there may be a
minor problem, therefore check the following.
Problem
The appliance does not operate
The appliance performs poorly
There is a noise
IMPORTANT NOTES
• In case of a sudden power loss or disconnecting
reconnecting of the plug to the electrical socket,
the compressor's protective thermal element
will be opened as the pressure of the gas in the
cooling system of your larder has not yet been
balanced. 4 or 5 minutes later, your larder will
start to operate; this is normal.
• If you will not be using your larder for a
long period (holiday etc.), disconnect the plug
from the socket. Clean your larder as per
page 15 of this document and leave the door
open to prevent any humidifi cation or odour
forming. If there is still a problem with your larder
despite followed the instructions in this manual,
please consult your nearest authorised
service centre, or the Customer Helpline on
0845 600 4632.
16
Possible Causes
There is a power failure
The mains plug is not properly
plugged in, or is loose
The thermostat setting is on
position "0"
You have overloaded the appliance
The doors are not closed perfectly
The cooling gas which circulates in
the larder circuit may make a slight
noise (bubbling sound) even when
the compressor is not running. Do
not worry, this is quite normal. If
these sounds are different check if
• The appliance is installed fi rmly
as described in the section of this
instruction manual
• Objects on the appliance are
vibrating
Conformity Information
• Normal Class is defi ned as environment
• The appliance is designed in compliance
Possible Solutions
The socket is defective. To check
this, plug in a fully operable
appliance into the same socket
There are not enough ventilation
ducts on the kitchen unit as
mentioned in the Installation section
of this instruction manual
The life-cycle of this product, as determined and
proclaimed by the Ministry of Industry (the period
for making spare parts available for the product
to be able to fulfi l its function), is 10 years.
temperatures between 16°C and 32°C in
accordance with TS EN ISO 15502 standards.
with EN15502, IEC60335-1/IEC60335-2-24,
2004/108/EC standards.
Customer Helpline 0845 600 4632