Pfaff 2144 Instruction Manual page 23

Embroidery / card – single designs
Machine's memory
Use this function to access the stitch selection of the machine or to call up the machine's memory.
Front card drive
Use this function to access the front card drive.
Rear card drive
Use this function to access the rear card drive.
End to end mirroring
With this function, you can mirror a design end to end. The mirrored design then appears on the screen for further
processing.
Side to side mirroring
With this function, you can mirror a design side to side. The mirrored design then appears on the screen for further
processing.
Trouble shooting, e.g. thread breakage
With this function you can open a window showing troubleshooting functions to remedy problems that may occur
during embroidering, e.g. thread breakage.
Stitch number
Use this function to open a window for entering a stitch number to which the embroidery hoop moves after the con-
firmation.
Advance/Reverse stitch by stitch
With this function you can advance/reverse stitch by stitch, including across a change of color.
Advance/Reverse design by design
Within an embroidery combination, use this function to advance/reverse the embroidery hoop design by design.
Advance/Reverse color by color
Use this function to move the embroidery hoop to the start of the previous/next color within a design. The color
appears in the icon.
Start of color
This positions the needle at the start of the current color.
The color is displayed in the icon. The window is automatically opened in case of thread breakage.
Cross-hair cursor
This switches on a cross-hair cursor, which shows you the current needle position.
Changing the color
With this function, you open a window for processing the color segments further.
The window is sub-divided into three fields in which you can make changes.
If you confirm your input, this command affects all 3 fields and the window is closed.
Top field / Select color segment
1. In this field you can select a color segment in order to change it. To do this, mark the color segment that is to be
changed, using the cursor icons. Only the selected color segment is displayed.
2. You can select a color segment in order to sew only this segment. To do this, press the foot control after marking
the color.
If you set the cursor to M, the machine embroiders all areas in the same color.
Middle field / Change color
In this field you can use the cursor keys to mark the color to which you would like to change the selected color seg-
ment.
Bottom field / Color intensity
In this field, you can adjust the shade of a color of the selected segment with the cursor keys.
Enlarged representation
With this function, you obtain an enlarged representation of the design on the screen, as upon design selection. By
touching "esc" you switch back to the previous screen, without saving the changes.
1-17